EBS CPX200NB - Page 23

CPX200NB ALARM CONTROL UNIT – USER MANUAL 23 / 30
EN
Getting the name of partition
Command syntax
XXXX GETNAME=PARTITION,NR
Command description
Acquiring the name of the partition
XXXX – user code
NR – number of the partition, possibile values: 1 or 2
Example: 1234 GETNAME=PARTITION,1
Feedback message
GETNAME=PARTITION,NR,VALUE
or
GETNAME:ERROR
Feedback message
description
GETNAME=PARTITION,NR,VALUE – partition name
GETNAME:ERROR – command rejected by the system
Setting the phone number
Command syntax
XXXX SETTELNUM=ID,NUMBER
Command description
Setting the phone number for pointed index on the
phone number list
XXXX – user code
ID – index of phone number on the list, possible
values: 1 to 10
NUMBER – phone number, on which the texts will be
send
Example: 1234 SETTELNUM=3,800123456
Feedback message
SETTELNUM:OK
or
SETTELNUM:ERROR
Feedback message
description
SETTELNUM:OK – command accepted
SETTELNUM:ERROR – command rejected by the
system