EBS CPX200NB - Page 24

CPX200NB ALARM CONTROL UNIT – USER MANUAL 24 / 30
EN
Getting the phone number
Command syntax
XXXX GETTELNUM=ID
Command description
Getting the phone number for pointed index on the
phone number list
XXXX – user code
ID – index of phone number on the list, possible
values: 1 to 10
Example: 1234 GETTELNUM=2
Feedback message
GETTELNUM=ID,NUMBER
or
GETTELNUM:ERROR
Feedback message
description
GETTELNUM=ID,NUMBER – information about phone
number
GETTELNUM:ERROR – command rejected by the
system
Setting the content of text message
Command syntax
XXXX SETMESSAGE=ID,MESSAGE
Command description
Setting the content of text message under the
pointed index
XXXX – user code
ID – index of text, possible values: 1 to 32
MESSAGE – content of the text message
Example: 1234 SETMESSAGE=4,Robbery
Feedback message
SETMESSAGE:OK or SETMESSAGE:ERROR
Feedback message
description
SETMESSAGE:OK – command accepted
SETMESSAGE:ERROR – command rejected by the
system