ENGLISH
PLEASE NOTE: MINI TANKS ARE FOR INDOOR PERMANENT INSTALLATIONS ONLY. BEFORE POWERING THE WATER HEATER, BE SURE THAT THE SYSTEM IS COMPLETELY FILLED WITH WATER
AND ALL AIR IS REMOVED. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
3
Designed in
Summerville, SC
Support: Support.Eccotemp.com Shop Online: www.Eccotemp.com Phone: 866-356-1992
CAUTION! When a supplemental heat source is connected to the
Certied Household Electric Storage Tank Water Heater, provisions must
be made to limit the heat source temperature not to exceed that of the
water heater thermostat setting.
CAUTION! If the water heater has been retrotted with supplemental
heating equipment, you must adjust both the thermostat controlling the
supplemental heat source located in the water piping and the thermostat
on the water heater behind the access panel to the same temperature.
Failure to adjust both thermostats to the same temperature can cause loss
of proper temperature control.
CAUTION! To reduce the risk of electric shock or re, use only on a
utility supply having a maximum 125/250 volt, three wire system.
CAUTION! To reduce the risk of electrical shock, connect ground to
water heater. For detailed information refer to instructions.
CAUTION! Install temperature and pressure protective equipment
required by local codes, but no less than a combination temperature
and pressure relief valve certied as meeting the requirements for relief
valves, ANSI 21.22, by a nationally recognized testing laboratory that
maintains periodic inspection of production of listed equipment or
materials. The valve must be oriented, provided with tubing, or otherwise
installed so that discharge can exit only within 6 inches above, or at any
distance below, the structural oor, and cannot contact any live electrical
part.
DANGER! To reduce the risk of electric shock, disconnect from power
supply before replacing temperature-limiting device.
CAUTION! A damaged power supply cord must be replaced with
one supplied by the unit manufacturer and not repaired.