ENGLISH
PLEASE NOTE: MINI TANKS ARE FOR INDOOR PERMANENT INSTALLATIONS ONLY. BEFORE POWERING THE WATER HEATER, BE SURE THAT THE SYSTEM IS COMPLETELY FILLED WITH WATER
AND ALL AIR IS REMOVED. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
9
Designed in
Summerville, SC
Support: Support.Eccotemp.com Shop Online: www.Eccotemp.com Phone: 866-356-1992
Installation Instructions
CHOOSE A LOCATION
Select a location that allows ease of access for maintenance, ideally with at
least 9 inches of clearance at the top from any ceiling or cabinet interior.
Note: Only install in a vertical position.
A licensed professional should complete the installation adhering to all state
and local codes. The manufacturer will not be liable for any damages because
of failure to comply with these installation instructions or because of improper
installation performed by a qualied installer.
Wall Mounted
Fasten the supplied mounting
bracket to the wall. Use screws that
are suitable for the wall material
and the weight of the water heater
lled to capacity (EM-2.5-41 lbs.;
EM-4.0-58 lbs.; EM-7.0-88 lbs). Hang
the water heater on the bracket and
pull downwards on the water heater
to ensure that both ngers of the
bracket are seated in the mounting
slots.
Note: Conrm your water piping
orientation (hot and cold) before
wall mounting.
Free Standing
Sit on the oor under a sink or in a
cabinet, upright, as pictured in the
diagram below and on the front cover
of this manual.
Note: Make sure to leave at least
nine (9) inches of clearance above your
water heater.
Wall MountedFree Standing on Floor
Wall
Anchor
Wall MountedFree Standing on Floor
Wall
Anchor