Need help?Do you have a question about the ECD OvenRIDER NL2+ and is the answer not in the manual?
General| Brand | ECD |
|---|---|
| Model | OvenRIDER NL2+ |
| Category | Controller |
| Language | English |
Describes methods to access the software's help system using the Help button, F1 key, or Help menu.
Details the 3 thermal and 3 position sensors used for measuring oven performance.
Explains the function of the zone sensor light, which illuminates when zone boundary magnets are detected.
Identifies the protective Thermal Barrier for the M.O.L.E.® Profiler.
Explains the barrier locking latch that secures the cover to prevent accidental opening.
Identifies the zone sensor battery as the power source for the zone sensor light.
Indicates the connector bridge where the M.O.L.E.® Profiler connects to the RIDER.
Describes the extractor handle used to disconnect the M.O.L.E.® Profiler from the connector bridge.
Details connecting the USB cable to charge the power pack, noting charge times for full and quick charges.
Instructs inserting a flash drive and launching Windows Explorer to begin software installation.
Explains obtaining an unlock key and completing software registration via online or manual methods.
Details connecting the computer interface cable to the profiler for communication setup.
Guides on installing zone boundary magnets using provided clips and determining placement.
Introduces the procedure for setting up the OvenRIDER® NL 2+ for data runs and using MAP software.
Outlines opening MAP software and connecting the profiler to the computer for setup.
Details the process of data collection, including connecting the profiler and pressing the record button.
Explains connecting the profiler to a computer and selecting the 'Read Instrument' command to start downloading.
To Next Page
