4 6 INCH CHIPPER
SAFETY
1.9 SAFETY DECALS
Keep hands and feet out of inlet and discharge openings
while machine is operating to avoid serious personal
injury. Stop and allow machine to come to a complete
stop before clearing obstructions.
Read and understand this owner/operators
manual. Be completely familiar with the controls
and the proper use of this equipment
Obtain and wear safety glasses and use hearing
protection at all times when operating this
machine.
Before inspecting or servicing any part of this
machine, shut o power source, remove the
key, disconnect spark plug wire from spark plug
and make sure all moving parts have come to a
complete stop.
Do not operate this equipment in the vicinity of
bystanders. Do not allow children to operate this
equipment. Always stand clear of discharge area when operating this
machine. Keep face and body away from discharge areas.
Do not operate machine without shields in place.
Failure to do so may cause serious injury or death.
Check blade bolts for proper torque after
every 8 hours of operation. Check blades
and rotate or resharpen daily or as required
to keep blades sharp. Refer to owners manual for instructions. Failure
to do so may cause poor performance, damage or personal injury and
will void the machine warranty.
Read and understand you owners manual before operating. If owners
manual was not included or you have any questions, please call
800.247.7335 or 701.282.5520 (U.S.A.).
See Section 1.10 for decal locations. Familiarize yourself with all of the safety and operating decals on the machine
and the associated hazards. See the engine owner's manual or contact the engine manufacturer for engine safety
instructions and decals.
Keep hands and feet out of inlet and discharge
openings while machine is operating to avoid
serious personal injury. Stop and allow
machine to come to a complete stop before clearing obstructions.
1
6
2
7
3
4
5
PN 12169
PN 12172
PN 12173
PN 12174
PN 12175
PN 14942-00
PN 12250
Do not operate this equipment in the vicinity
of bystanders. Do not allow children to
operate this equipment. Always stand clear
of discharge area when operating this
machine. Keep face and body away from
discharge areas. Rotate the discharge tube over the hitch before towing
and lock securely in place.
350 kPa, 50 psi
P205/75R14
68
150
9
10
8
Feed roller support must be secured
in the up position prior to servicing
chipper feed area. The feed roller
can fall and cause severe bodily harm. Consult owners manual for
proper method of securing feed roller support. Lower feed roller before
operating chipper.
PN 32109-00
PN 32155-00
PN 18983-00
Operation of this equipment may create
sparks that can start res around dry
vegetation. A spark arrestor may be
required. The operator should contact
local re agencies for laws or regulations
relating to re prevention requirements.
11
PN 33883-00
33883-00
WARNING
ADVERTENCIA
OPERATION OF THIS EQUIPMENT MAY CREATE SPARKS
THAT CAN START FIRES AROUND DRY VEGETATION. A
SPARK ARRESTOR MAY BE REQUIRED. THE OPERATOR
SHOULD CONTACT LOCAL FIRE AGENCIES FOR LAWS
OR REGULATIONS RELATING TO FIRE PREVENTION
REQUIREMENTS.
EL USO DE ESTE EQUIPO PUEDE CREAR CHISPAS
CAPACES DE INICIAR INCENDIOS EN VEGETACION
SECA. PODRIA SE NECESARIO USAR UN PARACHISPAS.
EL OPERADOR DEBERA COMUNICARSE CON CUERPOS
DE BOMBEROS LOCALES PARA INFORMARSE DE LEYES
O REGLAMENTOS RELACIONADOS CON LOS
REQUISITOS EXIGIDOS PARA LA PREVENCION DE
INCENDIOS.
To Next Page
Loading...
