OPERATION CS-352
34 X7503275704
© 09/20 ECHO Incorporated
Stopping
1. Release throttle trigger and allow
engine to idle.
2. Move ignition switch (A) DOWN
to “STOP” position.
Note: If engine does not stop,
pull choke control knob out
fully to stop engine.
Note: Return the unit to your
authorized dealer to check
and repair stop switch before starting the engine again.
Checking Chain Tension
Chain tension should be checked
frequently during work and corrected
as necessary.
Do not operate with a loose chain.
Chain Lubrication Test
Hold the chain just above a dry
surface and open the throttle to half
speed for 30 seconds.
A thin line of “thrown” oil should be
seen on the dry surface.
Shown with optional
Kick Guard
TM
Shown with optional
Kick Guard
TM
To Next Page
Loading...
