PB-580H/T OPERATION
X7505200705 29
© 12/2017 ECHO Inc.
ENGLISH
5. Choke
After engine fires (or 5 pulls),
move choke lever back to RUN
( ) position, then pull starter
handle/rope until engine starts
and runs. Allow unit to warm up
at idle for several minutes.
Note: If engine does not start
with choke in “RUN”
position after 5 pulls,
move choke to COLD
START ( ) position,
and repeat steps 3- 5.
6. Throttle Lever
Allow engine to warm up for several minutes before use.
7. Throttle Lever
After engine warm-up, move throttle lever gradually to increase engine
RPM to desired operating speed.
Starting Warm Engine
The starting procedure is the same
as Cold Start except DO NOT close
the choke.v
1. Throttle Lever
Move throttle lever (A) to IDLE
position.