P
OWER
P
RUNER
TM
O
PERATOR
'
S
M
ANUAL
33
STORAGE
Long Term Storage (over 30 days)
Do not store your unit for a prolonged period of time (30 days or longer) without performing
protective storage maintenance which includes the following:
1. Store unit in a dry, dust free place, out of the reach of children.
WARNING DANGER
Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark.
A
2. Place the stop switch (A) in the "STOP" position.
3. Remove accumulation of grease, oil, dirt and debris from exterior of
unit.
IMPORTANT
Some tree sap and resins are corrosive. Thoroughly wash the
guide bar and sprocket areas after each use, then coat metal parts
with light oil.
4. Perform all periodic lubrication and services that are required.
5. Tighten all the screws and nuts.
6. Drain the fuel tank completely and pull the recoil starter handle
several times to remove fuel from the carburetor.
7. Remove the spark plug and pour 7 cc (1/4 oz.) (1/2 tablespoon) of
fresh, clean, two-stroke engine oil into the cylinder through the
spark plug hole.
A. Place a clean cloth over the spark plug hole.
B. Pull the recoil starter handle 2-3 times to distribute the oil inside
the engine.
C. Observe the piston location through the spark plug hole. Pull
the recoil handle slowly until the piston reaches the top of its
travel and leave it there.
8. Install the spark plug (do not connect ignition cable).
9. Install the guide bar cover on guide bar and saw chain.
To Next Page
Loading...
Need help?
General