MAINTENANCE PPT-2620
32 X7507820600
© 2/2017 ECHO Inc.
• W h e n r e a d y t o c u t :
Hold the cutting shoe against the
branch. This will prevent whipping
of the branch. DO NOT use back
and forth sawing action.
• Look out for branches
immediately behind the branch
being cut. If saw chain hits a rear
branch damage to the saw chain
and guide bar may occur.
• Accelerate to full throttle.
• Ease cutting pressure when
nearing end of cut to maintain
control
• When pruning a limb 102 mm
(4 in.) diameter or larger cut as
follows:
1. Under cut 1/4 limb diameter near tree trunk.
2. Finish top cut slightly farther out on limb.
3. Flush cut stub at trunk.
• DO NOT use for felling or bucking.
MAINTENANCE
Moving parts can amputate fingers or cause severe injuries.
Keep hands, clothing and loose objects away from all openings.
Always stop engine, disconnect spark plug, and make sure all
moving parts have come to a complete stop before removing
obstructions, clearing debris, or servicing unit. Allow unit to
cool before performing service. Wear gloves to protect hands
from sharp edges and hot surfaces.
Blade Hits Rear Branch
Not Correct
To Next Page
Loading...
Need help?
General
