PPT-2620 STORAGE
X7507820600 49
© 2/2017 ECHO Inc.
ENGLISH
Some tree sap and resins are corrosive. Thoroughly wash the guide
bar and sprocket areas after each use, then coat metal parts with light
oil.
4. Perform all periodic lubrication and services that are required.
5. Tighten all the screws and nuts.
6. Drain fuel tank completely. Press purge bulb 6–7 times to remove
remaining fuel from carburetor then drain the tank again. Close choke,
start and run the engine until it stops due to lack of fuel.
7.
a. Allow engine to cool then remove the spark plug and pour 7 cc (1/4
oz.) of fresh, clean, two-stroke engine oil into the cylinder through
the spark plug hole.
b. Pull the recoil starter handle 2–3 times to distribute the oil inside the
engine.
c. Observe the piston location through the spark plug hole. Pull the
recoil handle slowly until the piston reaches the top of its travel and
leave it there.
8. Install the spark plug.
9. Install the sprocket guard on the guide bar and saw chain during
storage.
To Next Page
Loading...
Need help?
General
