Echo Pro Attachment PAS-225 - Idle Speed Carburetor Adjustment; Lubrication and Gear Housing Maintenance

PAS-225VP MAINTENANCE
© 12/2013 ECHO Inc.
X7722273906 27
Note: Every unit is run at the factory and the carburetor is set in compliance with emission regulations.
Carburetor adjustments, other than idle speed, must be performed by an authorized ECHO dealer.
1. Check idle speed and reset if necessary. If a tachometer is
available, idle speed screw (A) should be set to the
specifications found on “Specifications” page of this manual.
Turn idle screw (A) clockwise to increase idle speed; counter
clockwise to decrease idle speed.
When carburetor adjustment is completed, the cutting
attachment should not move at idle, otherwise serious
personal injury may result.
Lubrication
Level 1.
Gear Housing
1. Clean all loose debris from gear box.
2. Remove plug (A) and check level of grease.
3. Add grease if necessary. DO NOT over-fill.
Parts
Required:
POWER BLENDX
TM
8 oz. or Lithium Base
Grease.
A
A
C
D
B
A