Eclipse AVN6000 - Adjusting Volume Balance

30
Adjusting sound quality
Basic operation
Adjusting volume balance
The set position for front-to-back, right-to-left volume balance can be adjusted.
Touch on the
POSITION setting screen to
display the volume balance
adjustment screen.
Touch the screen at the preferred
balance point.
• To make fine adjustments, touch ,
, , .
• Touching will set the
volume balance to the centre position.
• After making settings, touch .
• The set volume balance will be saved
and the system will return to the
previous operation screen.
• To set the POS again, touch .
FADER BALANCE
CENTER
BACK
POS
• This setting cannot be done at the same time as POS (position selector)
adjustment, described on the previous page.
• Touching and holding , , or while making fine adjustments will
adjust values in a continuous action. However, adjustment will lock when it
reaches the centre value, and , , or must be pressed again to
continue adjustment.