Maintenance
Maintenance
Replace the rammer cap, using the
5/32nd" hex key to secure it into the
Eclipse Ego body
(See Figure 6.35)
.
Lubricate all of the seals on the
rammer shaft and replace the
rammer into the rear of the Eclipse
Ego body with the bumper at the
back
(See Figure 6.34)
. Note: Use
light paintgun oil.
Noting the position of the rammer
in the Eclipse Ego body
(See Figure
6.36)
, replace the bolt and locate
the bolt pin into the designated
groove in the rammer shaft
(See Figure 6.37)
.
FIGURE 6.31
FIGURE 6.32
FIGURE 6.33
FIGURE 6.34
FIGURE 6.35
FIGURE 6.36
FIGURE 6.37
To Next Page
Loading...
