Maintenance
Cleaning and Lubricating
the Rammer
Pull the bolt pin upwards so that it dis-engages the
rammer, allowing the bolt to be removed via the rear of
the Eclipse Ego
(See Figure 6.28)
.
Using a 5/32nd" hex key, unscrew and remove the
rammer cap at the rear of the Eclipse Ego
(See Figure 6.29)
.
Raise the front of the Eclipse Ego and tap the Eclipse
Ego onto your hand until the rammer falls into the palm
of your hand
(See Figure 6.30)
.
Thoroughly clean the rammer shaft and all of its seals,
paying special attention to the seal on the middle of the
shaft
(See Figure 6.31)
, the rear seal
(See Figure 6.32)
and
the condition of the bumper at the rear of the shaft
(See Figure 6.33)
. Replace any worn seals/bumpers
using authentic Eclipse Ego spare parts.
WARNING
:
De-gas your marker,
discharging any stored gas in a safe direction,
and remove the barrel and loader to make the
Ego easier to work on.
FIGURE 6.28
FIGURE 6.29
FIGURE 6.30
Maintenance
Maintenance
46
47
To Next Page
Loading...
