Fault Finding
Fault Finding
Symptom Possible Cause Solution
My trigger is very “Bouncy”, how
can I reduce it?
Increase the trigger transition filter
settings.
Check that your trigger pull is within
the limits of your TT BAND setting
and that your TT TOL suits your
current set-up.
Lengthen and strengthen your
trigger pull.
Refer to the Advanced Set-up
Section for guidelines of how to
adjust your Ego trigger accordingly.
The Break Beam Sensor System
does not appear to be reading
correctly.
The Break Beam Sensor System
is dirty.
Keep the break beam sensors
clean to ensure correct readings
(see Maintenance Section).
The Break Beam Sensor System is
not reading at all.
There is a broken wire or contact,
or a short circuit on either of the
breech sensor ribbon cable.
Check the plug of the cable.
Check for cuts or pinches in the
sensor cables.
Either sensor is back to front. Check that sensors face each other
when installed.
Two or more balls are being fed into
the breech.
If the Eclipse Ego is being used
with a force feed loader, it is
possible that the loader is forcing
balls past the ball detent.
Change the rubber finger detent.
To Next Page
Loading...
Need help?
General
