52
Accelerating the path to discovery
®
Procedure
Perform when using heating mantles with round bottom asks. [This procedure takes about 2 minutes to perform]
1.
Press and hold in both the
and
keys on the front of the temperature meter until the word “tunE” appears in the display,
then release both keys.
2.
Press the
key once and the word “bAnd” will appear in the display.
First hold in the ‘*’ key, then while holding in the ‘*’ key press the
or
key until the value “10” appears in the display, then
let go of all the keys.
3.
Press the
key once and the word “int.t” will appear in the display.
First hold in the ‘*’ key, then while holding in the ‘*’ key press the
or
key until the value “10” appears in the display, then
let go of all the keys.
4.
Press the
key once and the word “dEr.t” will appear in the display.
First hold in the ‘*’ key, then while holding in the ‘*’ key press the
or
key until the value “50” appears in the display, then
let go of all the keys.
5.
Press the
key once and the word “dAC” will appear in the display.
First hold in the ‘*’ key, then while holding in the ‘*’ key press the
or
key until the value “3.0” appears in the display,
then let go of all the keys.
6.
Press the
key once and the word “CyC.t” will appear in the display.
First hold in the ‘*’ key, then while holding in the ‘*’ key press the
or
key until the value “30” appears in the display, then
let go of all the keys.
7.
Press and hold in both the
and
keys until the temperature appears in the display, then release
both keys.
The controller is programmed to display temperature with 0.1°C resolution. The controller can also display 1°C
resolution by following the procedure below (the display can also be changed to read in °F, call for information).
There are two reasons to change the display resolution:
A. To enter a setpoint faster (the display scrolls 10x faster in 1° mode than in 0.1° mode).
B. To display temperatures above 999.9° which is very rare.
3.8 Changing the Temperature Display Resolution
High Powered Heating Mantle Controllers