ecodyst Hydrogen - Maintenance

42 Accelerating the path to discovery
®
Ecodyst Scientic, Inc. mantles do not require regularly scheduled maintenance. However, regular inspection
is recommended, and damaged mantles should be removed from service immediately. Ecodyst Scientic, Inc.
mantles should be protected from chemical spillage, mechanical damage, and corrosive atmospheres as far as
possible. Below are some regular maintenance and inspection tips that help ensure the operational longevity and
eciency of the heating mantles.
1. If the machine is not in use, unplug from the temperature controller, clean the machine, and keep it dry.
2. Please disconnect the power cord before cleaning the machine.
3. Before exchanging a component for repair, you MUST rst troubleshoot and seek technical help from the
Ecodyst Scientic, Inc. engineering team. Ecodyst Scientic, Inc. further suggests using an original component
supplied by the manufacturer.
4. The manufacturer will handle the breakdown of the equipment notwithstanding normal/proper usage
throughout the warranty term mentioned on the warranty sheet included in this Operation handbook.
5. Before cleaning, make sure the machine is completely OFF, unplugged from the controller, and cooled down.
Ecodyst suggests using neutral detergent and a DFT cloth to clean the machine. Avoid the use of abrasive
fabric, stinging agents, and organic solutions.
6. The manufacturer is not responsible for breakdowns caused by ignoring the warnings and cautions in their manual.
Maintenance
Except for fastening components, electrical connections, and cable sets, spare parts for Ecodyst Scientic, Inc. heating
mantles are not widely accessible. A full spare mantle is normally required to store additional spare components.
Spare Parts
1. Upon initial start-up, the controller is likely to give o a smokey or burning smell. This should be expected as it
indicates the rst use of the machine. If alarmed, kindly, contact Ecodyst for technical direction and advice.
2. Never plug the controller directly into an electrical wall receptacle. It can only be plugged into the receptacle of
the approved temperature controller. Failure to heed this will overheat and damage the controller, and likely
cause hazardous scenarios up to and including electrical shocks, re, burns, and even death.
Additional Safety Warnings
High Powered Heating Mantle