EasyManua.ls Logo

ecodyst Hydrogen - Personnel Qualification; Operating Companys Obligations

ecodyst Hydrogen
69 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Accelerating the path to discovery
®
The device may only be operated by qualied persons.
The device may only be operated by individuals who have been instructed in its proper use by qualied persons.
The device may only be operated and maintained by persons who are of legal age.
Other personnel may only work with the unit under continuous supervision of an experienced qualied
operator.
This manual must be read and understood by all persons working with the device.
The personnel must have received special safety instructions in order to guarantee responsible and safe work
procedures.
Personnel Qualication
Changes to the Unit
No unauthorized changes may be made to the unit.
No parts may be used which have not been approved by the manufacturer.
Unauthorized changes result in the EC Declaration of Conformity losing its validity, and the appliance may no
longer be operated.
The manufacturer is not liable for any damage, danger or injuries that result from unauthorized changes or
from operating the unit other than described in this manual.
Installation Site
The device must be positioned in a suitable location.
The device must be installed suciently stable on a strong and level surface.
All screw connections must be securely tightened.
The device should be located as close as possible to the process requiring cooling.
The device should not be installed closer than 1.4 meters (4 feet) to a heat-generating source, such as heating
pipes, boilers, etc.
If possible, the device should be located near a suitable drain to prevent ooding in the event of leaks.
Do not place the device where corrosive fumes, excessive moisture, excessive dust, or high room temperatures
are present.
The site must have an 80% relative humidity and temperature between 5–35 °C
Adequate clearance should be allowed on the front, sides, top, and rear of the device for access to connections
and components.
The front and side vents of the device must be a minimum of 21 cm (8 inches) away from walls or vertical
surfaces, so air ow is not restricted.
Operating Company’s Obligations
General Safety Instructions