1|
Safety Instruction
General
1. Please carefully read the documents before
installing, operating or maintaining the
equipment. The documents are subject to change
due to product updates or other reasons.
2. Do not put heavy objects on the equipment.
3. Ensure that all cables and connectors are intact
and dry before connecting to prevent electric
shocks.
4. Use insulation tools or wear personal protective
equipment when you install or operate the
equipment.
5. Do not install or operate the equipment in
extreme weather events such as lightning, snow,
heavy rain, strong wind and so on.
6. Do not damage, smear or rip off any warning
labels on the equipment.
7. Do not hit, pull, drag, squeeze or step on the
equipment, or throw it into the re, as there is risk
of explosion.
8. After installing, please clean the remains of the
installation, such as boxes, clipped cable ties,
ripped insulation materials, etc.
9. Do not modify or repair the equipment, please
contact our customer service or qualied
personnel if necessary.
10. Use tools and the equipment correctly to prevent
personal injuries and product damage.
11. Understand the components and function of the
grid-tied PV power system. Make sure that all
electrical connections, and voltage and frequency
at the connection point meet the local
microinverter grid-tied requirements.
12. Make sure the screws are tightened to the
specied torque during installation (M5x12: 30
Kgf*cm; ST5x25: 45 Kgf*cm; M6x20: 90
Kgf*cm).
13. If you only connect solar panels and the battery
with the microinverter without plugging into the
AC outlet, the microinverter shall be grounded.
14. It is strongly recommended to install an
overcurrent circuit breaker between the
equipment and the grid.
15. The equipment may get more than 70 °C (158
°F) while in use. Do not touch its enclosure before
it cools down. Also, always keep the equipment
out of reach of children and pets.
16. The installation location should be convenient for
you to pull out the connectors.
17. Before you pull out the AC (or battery) connector
from the microinverter, disconnect the cable from
the AC socket (or battery's) end.
18. Make sure the portable power station is off
during the whole connection process.
19. You can only connect solar panels to the PV port
and only connect an EcoFlow portable power
station to the battery port.
Environment requirements
1. Make sure the equipment is installed, operated or
stored in a well ventilated place.
2. Do not install or operate the equipment near
ammable, explosive, corrosive, caustic or moist
sources.
To Next Page
Loading...
