417101726_Ecoplus_PCB.docx
1 General Points
This Operating Instruction contains all required information on installing, starting up,
maintaining, and repairing the Ecoplus-PCB.
NOTE
The German sections of this manual constitute the ORIGINAL OPERATING
INSTRUCTIONS and take legal precedence.
All other languages are translations of the ORIGINAL OPERATING INSTRUCTIONS.
IMPORTANT
Please read this manual carefully and keep it as reference. If you have questions, please
contact us as outlined in chapter 1.3 Contact Address / Manufacturer.
1.1 Transport Damage
CAUTION
If the Ecoplus-PCB is found to have been damaged when it is unpacked, it should not be
installed!
WARNING
1.2 Extent of Warranty
All warranties concerning the operating safety, reliability and performance of the Ecoplus-
PCB are only given by the manufacturer under the following conditions:
- Assembly, connection, installation, maintenance and repair must be carried out by
qualified and authorized specialists.
- The Ecoplus-PCB must be used in accordance with the specifications given in the
technical manual.
- Only original equipment spare parts may be used for repairs.
In all other aspects, the general terms of warranty and performance conditions of
ECOLAB-Engineering GmbH shall apply.
1.3 Contact Address / Manufacturer
ECOLAB-Engineering GmbH
Raiffeisenstraße 7
D-83313 Siegsdorf
Tel.: (+49) 86 62 / 61 0
Fax: (+49) 86 62 / 61 2 35
E-mail:
engineering-mailbox@ecolab.com
To Next Page
Loading...
Need help?
General
