4.0 System Programming
All SCLS IV/AQUANOMIC EU IV programming is carried out at the SCLS/AQUANOMIC EU dispenser
according to the following steps.
1.
Enter programming mode of the SCLS/AQUANOMIC EU dispenser by pressing the [Program] key, your
password (default is 12345) and then the [Enter] key.
2.
Press the down arrow key until the cursor is located in front of the System Menu and then press the
[Enter] key.
3.
Press the down arrow key until the cursor is located in front of the “Fourth Product” selection, then press
[Enter].
4.
The “Fourth Product Installed” screen should be displayed. Press the [Choice] key until the Yes response is
indicated and then press the [Enter] key to save the change.
5.
Press the [Exit] key, the down arrow key and then the [Enter] key in order to access the “Formula Menu”.
6.
Edit the programmed formulas by selecting washer number, formula number and the edit grams/delay
choices. The gram amounts for the fourth product will be visible after the finish product grams. For further
information please see the SCLS/AQUANOMIC EU I/O Manual (Section 6.6.2.4).
SCLS IV/AQUANOMIC EU IV Dispensing Module Installation & Operation Manual
4-1
To Next Page
Loading...