EasyManua.ls Logo

Ecolab SCLS IV - Requirements and Specifications; Utility Requirements

Ecolab SCLS IV
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2.1
Requirements/Specifications
2.2
Utility Requirements
2.2.1
Electrical Supply Requirements
A constant 120 VAC/60 Hz. power source is required.
The pump Cabinet is shipped with a 9’ power cord.
For distance greater than 9’, the Pump Cabinet must be hard wired with conduit.
The double pole single throw ON/OFF switch is also a circuit breaker rated at 3.0 amps.
Total amperage draw during normal operation is approximately 2.5 amps.
2.2.2
Water Supply Requirements
A 3/8 MNHT hot water supply line is required. The NSF hose is shipped in the Installation Kit.
Water temperature should not fall below 95°F (35°C).
Water flow rate is 0.8 GPM.
2.2.3
Electrical
The SCLS IV/AQUANOMIC EU IV does not require any additional electrical or water service relative to the main
dispenser. The SCLS IV/AQUANOMIC EU IV runs on 24 volt electrical service originating from the main
dispenser cabinet. The SCLS IV/AQUANOMIC EU IV uses water from the main dispenser and therefore does
not require additional water hook up.
SCLS IV/AQUANOMIC EU IV Dispensing Module Installation & Operation Manual
2-1

Related product manuals