Ecosoft ROBUST 1000 - 2 Specifications and Components; Technical Specifications

32 33
This manual is the intellectual property of Ecoso. Copying and reprinng is prohibited. © 2016
INSTALLER AND USER GUIDE FOR REVERSE OSMOSIS SYSTEM ECOSOFT ROBUST 1000, ROBUST 3000
1
At feed water TDS of 1000 mg/L (ppm) and temperature of feed water of 25 °С (77 °F), ±10%.
2
If the pressure of water in your system does not meet the requirement, install a pressure booster pump to raise
it. If water pressure exceeds the upper limit, install a pressure regulator before the RObust .
3
Using the RObust with feed water temperature between 20 °С (68 °F) and 30 °С (86 °F) produces a lower rejec-
on rate and higher ow rate, which yields higher TDS of puried water. Using the system with feed water above
30 °С (86 °F) is advised against.
2. SPECIFICATIONS AND COMPONENTS
2.1 TECHNICAL SPECIFICATIONS
Parameter
Value
RObust 1000 RObust 3000
Puried water ow rate
1
, L/h
gpm
55–60
0.24–0.26
145–150
0.64–0.66
Feed water ow rate, L/h
gpm
110–130
0.48–0.57
290–310
1.28–1.37
Concentrate ow rate, L/h
gpm
55–65
0.24–0.26
145–150
0.64–0.66
Inlet water pressure, bar (psi) 2.0–5.0
2
(29–72.5)
Operang pressure, bar (psi) 5.0–7.0 (72.5–101.5)
Feed water temperature, °С (°F) 4…30
3
(39…86)
Ambient air temperature, °С (°F) 5…40
3
(41…104)
Connecon to water mains JG ¼ JG ⅜
Overall dimensions, H × W × D, mm
inсh
420 x 220 x 425
16.5 x 8.7 x 16.7
445 x 480 x 380
17.5 x 18.9 x 15.0
Weight, kg (lb), max. 6 (13) 25 (55)
Electrical rang 230 V, 50 Hz
110 V, 60 Hz (USA)
Power consumpon, W (hp), max. 80 (0.11) 250 (0.34)
Ingress protecon rang IP 54