EasyManua.ls Logo

Ecotec Monica Plus - Page 17

Ecotec Monica Plus
37 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
By pressing the button P3 on the display the alarm can be reset. Try and repeat lighting after the
cooling phase.
FAN BROKEN ALARM
• Smoke extractor encoder is
not functioning or not correctly
connected
• Contact local Service Technician
• No electricity supply to smoke
extractor
• Contact local Service Technician
• The smoke extractor is blocked • Contact local Service Technician
DEPRESSION ALARM
• The combustion chamber is dirty
• Follow the cleaning operations of the stove as per the
instructions manual
• The ue is blocked • Check that the ue is clear and clean
• The vacuum switch is
malfunctioning
• Contact local Service Technician
THERMAL ALARM WITH
RESET
• The thermostat with manual reset
has intervened
• Reset the thermostat pressing the button on the back of the
stove (see Figure below this table)
• The centrifugal fan is defective • Contact local Service Technician
• Combustion in the re pot is not
optimal
• Switch off the stove, clean the re pot and regulate
combustion with the setting of the pellets
HOT SMOKE ALARM
• Combustion in the re pot is not
optimal
• Switch off the stove, clean the re pot and regulate
combustion with the setting of the pellets
• The centrifugal fan is defective • Contact local Service Technician
• IF THE PROBLEM CONTINUES, CONTACT YOUR LOCAL
SERVICE TECHNICIAN.
SMOKE SENSOR ALARM
• The smoke sensor is
malfunctioning
• Contact local Service Technician
• The smoke sensor has been
disconnected from the board
• Contact local Service Technician
AUGER BLOCKED
ALARM
• The auger does not load pellets • Contact local Service Technician
Unscrew the protection cap and press
the button to reset the thermostat alarm.

Table of Contents

Related product manuals