EasyManua.ls Logo

Ecotec Monica Plus - 1 Introduction; Specifications

Ecotec Monica Plus
37 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
1. Introduction
This manual is designed for both the technician and the home owner.
Please read this entire manual before installing or operating your Ecoteck Monica Plus Freestanding
Wood Pellet Burning Heater. Failure to follow these instructions may result in property damage, bodily
injury or even death. Any unauthorized modication of the appliance or use of replacement parts not
recommended by the manufacturer is prohibited. All national and local regulations shall be complied
with when installing this appliance. Your local Nature’s Flame dealer will be happy to assist you in
obtaining information with regards to your local building codes and installation restrictions.
1.1 Specications
1.1.1 Rating label Location
Ecoteck Monica Plus Freestanding: The rating label is located on the back of unit.
*Note: Consumption will vary with the type of fuel used.
IMPORTANT: The above values were found during testing and may vary with the fuel type, climate and
installation style.
1.1.2 Clearances to Combustibles
This pellet heater requires oor protection which must be non-combustible, extending beneath the
stove the full width and depth of the unit including (150mm) in front for ember protection.
AS/NZS2918 states that a 300mm forward projecting and 200mm side projecting oor protector must
be used from any door opening extremity as an absolute minimum. Due to the operating nature of the
Monica Plus pellet heater where opening the door causes a loss of vacuum and the re will shut down
completely, meaning the likelihood of any hot embers or burning fuel escaping from the combustion
chamber is extremely minimal, a 150mm forward projecting oor protector will be sufcient.
Classication Testing Standard Description
Class I IP-20 Efciency: AS/NZS 5078:2007
Appliance: AS/NZS 4866:2007
Residential Wood Pellet Heater
Voltage 220- 240 Volt Current: 2.92 – 3.18 Amps Frequency: 50Hz
Max Power Requirement
550 watts
Unit with full hopper: 145kg Hopper Capacity: 15kg
Mean Flue Gas Temp –
High: 193 degrees
Mean Flue Gas Temp-
Medium: 174 degrees
Mean Flue Gas Temp-
Low: 158 degrees
Fuel Consumption –
High: 1.43 kg per hour
Fuel Consumption –
Medium: 1.16kg per hour
Fuel Consumption –
Low: 0.99kg per hour
Heat/Power Output –
High: 6.5kw
Heat/Power Output –
Medium: 6.1kw
Heat/Power Output –
Low: 5.0kw
Average Particular Emissions (dry weight)
0.31gms per kg
Average Emissions Rate
18mg/MJ
Average Efciency
85%
Gross Caloric Value of pellets (dry weight)
20.24MJ/kg
Fuel Type:
Wood pellets – 6mm dia, - complying
with draft standard AS/NZS 4014.6
2008

Table of Contents

Related product manuals