ECOVACS DEEBOT M82 - Cleaning Mode Selection

13
EN
AUTO Cleaning Mode
This is the most commonly used mode. In AUTO Cleaning Mode, DM82 cleans in a straight line and
changes direction when it meets an obstacle.
1
Spot Cleaning Mode
(1 Minute)
This mode is applicable for an area of highly
concentrated dirt or dust. In Spot Cleaning Mode,
DM82focusesonaspecicareatoclean.
2
MA X
AM
PM
AM
PM
* Beforeselectingacleaningmode,makesuretheAUTOModeButtononDM82ashesGREEN.If
not, press the AUTO Mode Button on the robot or the START/PAUSE Button on the Remote Control
to wake up the robot.
3.3 Cleaning Mode Selection
DM82 has several cleaning modes to choose from to effectively clean different floors. Cleaning
modes are selected using the Remote Control or the AUTO Mode Button on the robot.
Power OFF
Pause DM82. Move the Side Power Switch to
the OFF position.
6
* When DM82 is not cleaning, it is suggested to
keep it powered ON and charging instead of
powered OFF.
M A X
AM
PM
AM
PM
3. Operating and Programming