24
EN EN
5. Troubleshooting
No. Malfunction Possible Causes Solutions
4
DEEBOT
returns to the
Charging Dock
before it nishes
cleanng.
When battery power gets low,
DEEBOT automatically switches
to Return to Charger Mode and
returns to the Charging Dock to
recharge itself.
This is normal. No solution necessary.
Working time varies according
to oor surface, room complexity
and the selected Cleaning Mode.
This is normal. No solution necessary.
5
DEEBOT
will not clean
automatically at
scheduled time.
Intelligent Scheduling function is
cancelled.
Set Intelligent Scheduling. Please
refer to section 3.4 Intelligent
Scheduling for details.
DEEBOT is powered OFF. Power ON DEEBOT.
the robot's battery is low.
Keep DEEBOT powered ON and on
the Charging Dock to make sure it has
full battery to work at any time.
the robot's Suction Intake is
blocked and/or its components
are tangled with debris.
Power OFF DEEBOT, clean
the Dust Bin and invert the robot.
Clean the Suction Intake and Side
Brushes as described in section 4
Maintenance.
6
Remote Control
failure (effective
control range of
Remote Control
is 5m/16').
The battery in the Remote
Control need to be replaced.
Replace with a new battery making
sure it is installed correctly.
DEEBOT is powered OFF or the
robot’s battery is low.
Make sure DEEBOT is powered ON
and fully charged.
The infrared signal cannot be
transmitted because the Infrared
Emitter on Remote Control or the
Infrared Receiver on DEEBOT is
dirty.
Use clean dry cloth or the brush
side of the provided Multi-Function
Cleaning Tool to wipe the Infrared
Emitter on Remote Control and the
Infrared Receiver on DEEBOT.
There is other equipment
interfering with the infrared
signal to DEEBOT.
Avoid using the Remote Control
near other equipment using infrared
signals.
To Next Page