11
EN EN
3. Operating and Programming
3.2 Quick Start
*
Remove the Bumper Rail protection
sponges on both sides of the DEEBOT
before the first use.
Place the Charging Dock on a level floor
surface against the wall with the base
perpendicular to the ground. Keep the
immediate area 1.5m (5') in front of the charger
and 0.5m (1.6') on both sides of the charger
clear of objects and reective object surfaces.
Plug the Charging Dock in.
Attach Side Brushes to the bottom of
DEEBOT by pressing a brush into each slot
with the matching color until it clicks.
Charging Dock Placement
1
Install Side Brushes
2
Turn the robot’s Bottom Power Switch to the
ON position. “I”=power ON; “O”=power OFF.
DEEBOT is powered ON when the AUTO
Mode Button glows a continuous BLUE.
Power ON
3
*
When DEEBOT is not cleaning, it is
suggested to keep it powered ON and
charging instead of powered OFF.
To Next Page