34
Using BIOS
Onboard IDE Controller (Enabled)
Use this item to enable or disable the onboard IDE interface.
Onboard PCI S-ATA Controller (IDE)
Use this item to enable or disable the onboard PCI SATA controller.
USB Functions (Enabled)
Use this item to enable or disable the USB function.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto allows the
system to detect the presence of USB device at startup. If detected, the USB controller
legacy mode is enabled. If no USB device is detected, the legacy USB support is disabled.
Audio Controller (Enabled)
Use this item to enable or disable the onboard audio controller.
OnBoard LAN Function (Enabled)
Use this item to enable or disable the onboard LAN function.
OnBoard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network add-in
card with a remote boot ROM installed.
Serial Port1/2 Address (2F8&IRQ3/3F8&IRQ4)
Use this item to enable or disable the onboard COM1/2 serial port, and to assign a port
address.
Serial Port2 Mode (Normal)
If Serial Port 2 Address is not disabled, it allows you to set the Serial Port 2 Mode.
Parallel Port Address (378)(optional)
Use this item to enable or disable the onboard Parallel port, and to assign a port address.
Integrated Peripherals
This page sets up some parameters for peripheral devices connected to the system.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Integrated Peripherals
Onboard IDE Controller Enabled
Onboard PCI S-ATA Controller IDE
USB Functions Enabled
Legacy USB Support Enabled
Audio Controller Enabled
Onboard LAN Function Enabled
Onboard LAN Boot ROM Disabled
Serial Port1 Address 2F8&IRQ3
Serial Port2 Address 3F8&IRQ4
Serial Port2 Mode Normal
Parallel Port Address* 378
Parallel Port Mode* EPP+ ECP
ECP Mode DMA Channel* DMA3
Parallel Port IRQ* IRQ7
DISABLED: disables
the integrated IDE
Controller.
ENABLED: enables
only the Primary IDE
Controller.
Help Item
F10: Save and Exit+/-/: Value
Enter : Select
ESC: Exit
F9: Optimized Defaults
F1:General Help
: Move
mnlk
* Stands for optional item.