39
Using BIOS
Power on by RTC Alarm (Disabled)
This system can be turned off with a software command. If you enable this item, the
system can automatically resume at a fixed time based on the system RTC (realtime
clock). Use the items below this one to set the date and time of the wake-up alarm.
You must use an ATX power supply in order to use this feature.
Power on by PCIE Devices (Enabled)
This system can be turned off with a software command. If you enable this item, the
system can automatically resume if there is an incoming call on the PCIE LAN card.
You must use an ATX power supply in order to use this feature. Use this item to do
wake-up action if inserting the PCIE card.
Power Menu
This page sets up some parameters for system power management operation.
ACPI Suspend Mode [S3(STR)]
Use this item to define how your system suspends. In the default, S3(STR), the
suspend mode is suspend to RAM, i.e., the system shuts down with the exception of
a refresh current to the system memory.
Deep Power off Mode (Disabled)
This item allows users to enable or disable the Deep Power off Mode.
BIOS Setup Utility
ACPI Aware O/S [Yes]
ACPI Suspend Mode [S3(STR)]
Deep Power off Mode [Disabled]
Power on by RTC Alarm [Disabled]
Power on by PCIE Devices [Enabled]
Power on by PCI Devices [Enabled]
Power on by Modem Ring [Disabled]
Power on by Onboard LAN [Enabled]
Wake up by USB KB/Mouse [Enabled]
Restore On AC Power Loss [Off]
Select the highest ACPI sleep
state the system will enter
when the SUSPEND button is
pressed.
lk
+/-/Spacebar : Change Opt.
Enter : Select
F7: Load User default Settings
mn
:Move
F8: Save as User Default
Settings
F9: Load Default Settings
F10: Save & Exit Setup
ESC: Discard changes and Exit
Setup
Main Advanced Power Security Boot Options Exit
Version 2.14.1219. Copyright (C) 2002-2012, Acer Inc.
ACPI Adware O/S (Yes)
This item supports ACPI (Advanced Configuration and Power Management
Interface). Use this item to enable ACPI feature.
Power on by PCI Devices (Enabled)
This system can be turned off with a software command. If you enable this item,
the system can automatically resume if there is an incoming call through the PCI
device connected. You must use an ATX power supply in order to use this feature.
Use this item to do wake-up action if inserting the PCI device.
To Next Page
Loading...
Need help?
General
