33
Using BIOS
1st/2nd/3rd Boot Device (Hard Disk Drive/CD/DVD/Removable Dev.)
Use this item to determine the device order the computer used to look for an
operating system to load at start-up time. The devices showed here will be different
depending on the exact devices installed on your motherboard.
APIC Mode (Enabled)
This item allows you to enable or disable the APIC (Advanced Programmable Inter-
rupt Controller) mode.
APIC provides symmetric multi-processing (SMP) for sys-
tems, allowing support for up to 60 processors.
fHard Disk Drives (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
fCD/D
VD Drivers (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Hard Disk Drives
1st Drive ST3160023AS
Help Item
Specifies the boot
sequence from the
available devices.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Hard Disk Drives
mnlk
: Move
F10: Save ESC: Exit
Enter : Select
+/-/: Value
F9: Load Default Settings
F1: General Help
CD/DVD Drivers
1st Drive TSSTcorpDVD-ROM TS-
Help Item
Specifies the boot
sequence from the
available devices.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
CD/DVD Drivers Drives
mnlk
: Move
F10: Save ESC: Exit
Enter : Select
+/-/: Value
F9: Load Default Settings
F1: General Help
Press <Esc> to return to the Advanced Setup page.
To Next Page
Loading...
Need help?
General
