Floppy Drive Seek (Disabled)
If you enable this item, your system will check all floppy disk drives at start up.
Disable this item unless you are using an old 360KB drive.
Password Check (Setup)
If you have entered a password for the system, use this item to determine, if
the password is required to enter the Setup Utility (Setup) or required both at
start-up and to enter the Setup Utility (Always).
Boot to OS/2 > 64MB (No)
Enable this item if you are booting the OS/2 operating system and you have
more than 64MB of system memory installed.
L2 Cache (Enabled)
Leave these items enabled since all the processors that can be installed on
this board have internal cache memory.
System BIOS Cacheable (Enabled)
If you enable this item, a segment of the system BIOS will be cached to main
memory for faster execution.
SDRAM Timing by SPD (Enabled)
This item enables or disables the SDRAM timing defined by the Serial Pres-
ence Detect electrical.
SDRAM CAS# Latency (2.5)
This item determines the operation of SDRAM memory CAS (column address
strobe). It is recommended that you leave this item at the default value. The
2T setting requires faster memory that specifically supports this mode.
SDRAM Bank Interleave (2-Way)
Enable this item to increase SDRAM memory speed. When enabled, separate
memory banks are set for odd and even addresses, and upcoming byte of
memory is accessible while refreshing the current byte.
AGP Mode (4X)
This item provides the OnBoard VGA mode with three options of 1,2, 4 multi-
plied frequency.
AGP Comp. Driving (Auto)
This item signals the auto or manual driving current on AGP cards. Some AGP
cards need stronger driving current for operation. We recommend you set this
item to be default value.
Manual AGP Comp. Driving (CB)
This item decides the AGP current driving value while AGP Driving is set to
Manual.
AGP Aperture Size (64MB)
This option determines the effective size of the AGP Graphic Aperture, where
memory-mapped graphic data structures are located.
29
To Next Page
Loading...
