ECS K7VMM+ - Load Optimal Settings; Load Best Performance Settings; Features Setup Page

to leave this item at the default value.
Load Optimal Settings
If you select this item and press Enter a dialog box appears. If you press Y,
and then Enter, the Setup Utility loads a set of fail-safe default values. These
default values are not very demanding and they should allow your system to
function with most kinds of hardware and memory chips.
Note: It is highly recommended that users enter this option to load optimal val-
ues for accessing the best performance.
Load Best Performance Settings
If you select this item and press Enter a dialog box appears. If you press Y,
and then Enter, the Setup Utility loads a set of best-performance default val-
ues. These default values are quite demanding and your system might not
function properly if you are using slower memory chips or other low-
performance components.
Features Setup Page
This page sets some of the parameters for peripheral devices connected to
the system.
AMIBIOS SETUP – FEATURES SETUP
(C) 2000 American Megatrends, Inc. All Rights Reserved
OnBoard FDC Enabled
OnBoard Serial PortA 3F8h/COM1
OnBoard IR Port Disabled
OnBoard Parallel Port 378h
Parallel Port Mode ECP
Parallel Port IRQ 7
Parallel Port DMA 3
OnBoard Game Port 201h
OnBoard MIDI Port 300h
MIDI Port IRQ 10
OnBoard IDE Both
Ethernet Device Enabled
Audio Device Enabled
Modem Device Auto
USB Controller Enabled
USB Device Legacy Support Disabled
ThumbDrive Support For DOS Disabled
ESC : Quit ↑↓←→ : Select Item
F1 : Help PU/PD/+/- : Modify
F5 : Old Values (Shift)F2 : Color
F6 : Load BIOS Defaults
F7 : Load Setup Defaults
OnBoard FDC (Enabled)
This item enables or disables the onboard floppy disk drive interface.
OnBoard Serial PortA (3F8h/COM1)
These items enable or disable the onboard COM1 serial port, and assign a
port address.
OnBoard IR Port (Disabled)
This item enables or disables the Infrared port, and assigns a port address. If
32