F
F
e
e
a
a
t
t
u
u
r
r
e
e
s
s
Processor
• Support Socket 462 package CPU
• Supports AMD Athlon XP/Athlon/Duron processors
• Supports 200/266 MHz Front-Side Bus
Chipset
The VIA KM266 Northbridge and VT8235 Southbridge in this
chipset in accordance with an innovative and scalable archi-
tecture with proven reliability and performance. A few of the
chipset’s advanced features are:
• An advanced V-Link memory controller architecture that
provides the bandwidth up to 266 MB/s and performance
necessary for even the most demanding Internet and
2D/3D graphics
• Support for an 4xAGP interface providing vivid 2D/3D
graphics and video performance
Memory
• Two 168-pin DIMM slots for SDRAM memory modules
• Two 184-pin DIMM slots for DDR memory modules
• Support for 100/133 MHz memory bus
• Maximum installed memory is 2GB
Note: You cannot use SDRAM and DDR simultane-
ously.
Expansion Slots
• One CNR slot
• One 4X AGP slot for AGP 2.0-compliant interface
• Two 32-bit PCI slots for PCI 2.2-compliant bus interface
Onboard IDE
channels
• Primary and Secondary PCI IDE channels
• Support for PIO (programmable input/output) modes
• Support for Multiword DMA modes
• Support for Bus Mastering and Ultra DMA ATA 133
33/66/100/133 modes
Power Supply
and Power
Management
• ATX power supply connector
• ACPI and previous PMU support, suspend switch, key-
board power on/off
• Supports Wake on LAN
Audio
• Compliant with AC’97 2.1 specification
• 16-bit stereo full-duplex CODEC with fixed 48KHz sam-
pling rate
• 3 analog line-level stereo inputs with 5-bit volume control:
LINE-IN, CD-IN, AUX-IN
• 1 analog line-level mono input: PHONE-IN
• Three Audio Jacks – Line-Out, Line-In and Microphone-In
• Sound Blaster, Sound Blaster Pro Compatible
• Advanced power management support
Graphic
• Single cycle 128-bit 3D architecture
• 128-bit 2D graphic engine
• 8/16/32 MB frame buffer using system memory
• Supports AGP 4X 266 MHz mode up to 1GB/s bandwidth
• Supports 250MHz RAMDAC
• 2D/3D resolutions up to 1920x1440
• Supports AGP Revision 2.0 Spec. Compliant
2