1-10
17. Audio1 (Front Panel Audio Header, 10-1 pin)
This is an interface for the Intel front panel audio cable that allows
convenient connection and control of audio devices. By default, the
pins labeled LINE OUT_R/BLINE_OUT_R and the pins LINE
OUT_L/BLINE_OUT_L are shorted with jumper caps. Remove the
caps only when you are connecting the front audio cable.
18. NBFAN1 (Northbridge Fan Connector, 3 pin)
If you installed wrong direction, the chip fan will not work. Sometimes
will damage the chip fan.
19. CPUFAN1 (CPU Fan Connector, 3 pin)
Please note, a proper installation of the CPU cooler is essential to pre-
vent the CPU from running under abnormal condition or damaged by
overheating. The CPU fan connector supports maximum current up to
600 mA.
These Serial ATA connectors support SATA hard disks that you may
configure as a RAID set. Through the onboard SiS180 RAID controller
you may create a RAID 0, RAID 1, RAID 0+1, or multiRAID configu-
ration together with the RAID ATA133 connector.
14. FDD1 (Floppy Connector, 34-1 pin, Black)
Please connect the floppy drive ribbon cables to FDD. It supports
360K, 12M, 720K, 1.44M and 2.88M bytes floppy disk types.
15. CDIN1 (CD In Connector, 4 pin)
Connect CD-ROM or DVD-ROM audio out to the connector.
16. AUXIN1 (AUX In Connector, 4 pin)
Connect other device (such as PCI TV Tuner audio out) to the connec-
tor.
To Next Page
Loading...
Need help?
General
