3-12
OnChip USB Controller (All Enabled)
Enable this item if you plan to use the Universal Serial Bus ports on this motherboard.
USB 2.0 Support (Enabled)
Enable this item if your system supports USB 2.0.
USB Legacy Support (Enabled)
This item allows the BIOS to interact with a USB keyboard or mouse to work with MS-
DOS based utilities and non-Windows modes.
USB Mouse Support (Enabled)
Enables this item if you plan to use a mouse connected through the USB port in a
legacy operating system (such as DOS) that does not support Plug and Play.
Press <Esc> to return to the Integrated Peripherals page.
SuperIO Device (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Onboard FDC Controller [Enabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [ECP]
ECP Mode Use DMA [3]
Item Help
Menu Level
Phoenix-AwardBIOS CMOS Setup Utility
SuperIO Device
Onboard FDC Controller (Enabled)
This option enables the onboard floppy disk drive controller.
Onboard Serial Port 1 (3F8/IRQ4)
This option is used to assign the I/O address and interrupt request (IRQ) for onboard
serial port 1 (COM1).
Onboard Parallel Port (378/IRQ7)
This option is used to assign the I/O address and interrupt request (IRQ) for the
onboard parallel port.
F5:Previous Values F6:Performance Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
To Next Page
Loading...
Need help?
General
