ECS KV2 Extreme

5-17
5. Use <> <> to select disk, and press <Enter> to select disk, <Q>
to exit. When you press <Enter> on the disk you wanted, the RAID
Type will be changed from Single to RAID 0. An the disk you select
first will be the SOURCE disk.
6. Next, you will see a message “Split the SOURCE(DISK x) data to
RAID disks?”. Press <N> and <Enter> to create RAID 0 array only
or press <Y> and <Enter> to split the data from source disk to
other disks
4. Press <1>-<5> keys and <Enter> to select Block Size.
(Default:64K)
8. Besides, you also can select <2>Manual Create, see following
steps.