ECS KV2 Extreme User Manual

5-18
.
9. Press <Q> again to exit this BIOS utility and the red message frame
will show. Press <Y> and <Enter> to save changes.
10. Once the array has been created, you will need to FDISK and format
the array as if it were a new single hard drive.
7. Starting splitting action, the following frame will be shown.
8. After all steps finished, press ,<Q> until escape the setup menu and
RAID 0 array will be show on the top of the main frame.

ECS KV2 Extreme Specifications

General

Brand	ECS
Model	KV2 Extreme
Category	Motherboard
Language	English