28
Motherboard User’s Guide
Power Management Setup Page
This page sets some parameters for system power management operation.
ACPI Suspend Type
Use this item to define how your system suspends. In the default, S3 (STR), the
suspend mode is a suspend to RAM, i.e., the system shuts down with the excep-
tion of a refresh current to the system memory.
CMOS Setup Utility – Copyright (C) 1985-2005, American Megatrends, Inc.
Power Management Setup
Help Item
Select the ACPI
state used for
System Suspend.
Press <Esc> to return to the main menu setting page.
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F9: Load Default Settings
Parallel Port IRQ
Use this item to assign IRQ to the parallel port.
USB Functions
Use this item to enable or disable the USB function.
Legacy USB Support
Use this item to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB device at startup. If detected, the
USB controller legacy mode is enabled. If no USB device is detected, the legacy
USB support is disabled.
ACPI Suspend Type S3
PWRON After PWR-Fail Power Off
Resume By RING Disabled
Resume By PCI/PCI-E/Lan PME Disabled
Resume By PS2 KB (S3) Disabled
Resume By PS2 MS (S3) Disabled
Resume on RTC Alarm Disabled
Resume By RING
An input signal on the serial Ring Indicator (RI) line (in other words, an incoming
call on the modem) awakens the system from a soft off state.
PWRON After PWR-Fail
This item enables your computer to automatically restart or return to its operating
status.
To Next Page
Loading...
Need help?
General
