ECS P67H2-A2 User Manual

55
ATI CrossFire
TM
Technology Support
Chapter 5
ATI CrossFireX
TM
Technology Support
This motherboard supports the ATI CrossFireX
TM
Technology that allows you to
install multi-graphics processing units (GPU) graphics cards. Follow the installation
procedures in this section.
Requirements
1 Two identical CrossFireX
TM
ready graphic cards are needed for the setup of
2-way CrossFireX
TM
configuration.
2 You would need one CrossfireX
TM
bridge cable.
3 Make sure that your graphics card driver supports the ATI CrossFireX
TM
technology. Download the latest driver from the ATI website
(www.ati.com).
4 Make sure that your power supply unit (PSU) can provide at least the
minimum power required by your system.
Installing CrossFireX
TM
graphics cards
1. Insert the CrossFireX
TM
graphics cards into the PCIEX16 slots. Make sure that the
card is properly seated on the slot.
A. For 2-way configuration, install two graphic cards on PCIEX16_1 & PCIEX16_2
and connect them with the CrossFire
TM
Bridge.
* For reference only

ECS P67H2-A2 Specifications

General

Memory channels	Dual-channel
Number of memory slots	4
Maximum internal memory	32 GB
Supported memory clock speeds	1066, 1333, 1600, 1866, 2133 MHz
Processor socket	LGA 1155 (Socket H2)
Processor manufacturer	Intel
Compatible processor series	Intel Celeron, Intel Pentium
Maximum number of SMP processors	1
USB 2.0 connectors	3
Power fan connector	Yes
Number of SATA III connectors	6
Number of Parallel ATA connectors	0
USB 2.0 ports quantity	8
Ethernet LAN (RJ-45) ports	2
Audio chip	Realtek ALC892
Component for	PC
Motherboard chipset	Intel® P67
Audio output channels	7.1 channels
Motherboard form factor	ATX
Compatible operating systems	Windows 7 32 bit/64 bit
PCI Express slots version	2.0
On-board graphics card	No
RAID levels	0, 1, 5, 10
LAN controller	RealTek RTL8111E
Ethernet interface type	Gigabit Ethernet
BIOS type	AMI
ACPI version	-
BIOS memory size	32 Mbit

Weight and Dimensions

Depth	244 mm
Width	305 mm