46
IRQ [3-7, 9-15], NMI (Enabled)
This option determines whether any activity for IRQ 3-7/9-15 will cause the
system to wake from a power saving mode.
IRQ 8 Break Suspend (Disabled)
Determines whether the system will monitor IRQ 8 activity and wake the sys-
tem from a power saving mode when IRQ 8 is activated.
Resume by Ring (Disabled)
An input signal on the serial Ring Indicator (RI) line (in other words, an incom-
ing call on the modem) awakens the system from a soft off state.
Resume by PCI PME (Enabled)
This item specifies whether the system will be awakened from power saving
modes when activity or input signal of the specified hardware peripheral or
component is detected.
USB Port Wakeup from S3 (Disabled)
This option allows you to specify whether the system will be awakened from
power saving modes when activity or input signal of the specified hardware
peripheral or component is detected.
PS2KB Wakeup from S3 (Hot Key)
This option allows you to set hot key combination to turn on the system by
keyboard.
PS2MS Wakeup from S3 (Disabled)
This option allows you to set the mouse action to turn on the system.
Power Up by Alarm (Disabled)
When set to Enabled, the following three fields become available: Month
Alarm, Day of Month Alarm, and Time Alarm Upon arrival of the alarm time, it
will instruct the system to wake up.
When set to 0 (zero) for the day of the month, the alarm will power on your
system every day at the specified time.
** Reload Global Timer Events **
These fields determine which events waken the system from power saving
mode.
Primary/Secondary IDE (Disabled)
When this item is enabled, the system power will resume the system from a
power saving mode if there is any activity on primary or secondary IDE chan-
nels 0 or 1.
FDD, COM, LPT Port (Disabled)
When this item is enabled, the system will restart the power-saving timeout
counters when any activity is detected on the floppy disk drive, serial ports, or
the parallel port.
To Next Page
Loading...
