EDAN SE-1515 - Chapter 4 ECG Sampling; Initial Configuration; Entering Patient Information

SE-1515 PC ECG User Manual ECG Sampling
- 37 -
Chapter 4 ECG Sampling
Plug in the right sentinel, and double-click on the screen to start the software. The main
screen will be displayed as follows:
Figure 4-1 Main screen
4.1 Initial Configuration
When the software is started the first time after installation, an Initial Setting window will be
displayed, and you can configure parameters such as the hospital name, lead mode, and sequence.
NOTE: If you need to reinstall the software, reinstall it under the original directory.
Otherwise, you will have to reconfigure it.
4.2 Entering Patient Information
You can enter the patient information with the following two ways:
1. New Patient
Click New Patient on the main screen (Figure 4-1), and the New Patient window will be
displayed as follows: