SE-1515 PC ECG User Manual Cleaning, Care and Maintenance
- 86 -
Cleaning agents should be applied or removed using a clean, soft, non-abrasive cloth or paper
towel.
10.2.1 Cleaning the Sampling Box
WARNING
When the DX12 transmitter is used, turn off the power, disconnect the patient cable, and
take out the battery before cleaning.
1. Wipe the exterior surface of the equipment using a soft cloth dampened with the cleaning
solution until no visible contaminants remain.
2. Wipe off the cleaning solution with a fresh cloth or towel dampened with tap water after
cleaning until no visible cleaning agent remains.
3. Dry the equipment in a ventilated and cool place.
10.2.2 Cleaning the Patient Cable
1. Wipe the patient cable with a soft cloth dampened with the cleaning solution until no visible
contaminants remain.
2. Wipe off the cleaning solution with a fresh cloth or towel dampened with tap water after
cleaning until no visible cleaning agent remains.
3. Wipe off with a dry cloth to remove residual moisture.
4. Leave the patient cable to air dry.
CAUTION
Any remainder of cleaning solution should be removed from the sampling box and the
patient cable after cleaning.
10.2.3 Cleaning the Reusable Electrodes (for Resting ECG)
1. Wipe off with a soft cloth to remove residual gel.
2. Wipe the suction bulbs of chest electrodes and the clamps of limb electrodes with a soft cloth
dampened with the cleaning solution until no visible contaminants remain.
3. Wipe off the cleaning solution with a fresh cloth or towel dampened with tap water after
cleaning until no visible cleaning agent remains.
4. Wipe off with a dry cloth to remove residual moisture.
5. Leave the suction bulbs and clamps to air dry.
To Next Page
Loading...
