Edge-Core EAP102 - AP Setup Wizard; Figure 2: Select Eccloud, EWS Controller, or Stand-Alone

Chapter 1 | Introduction
AP Setup Wizard
– 21 –
AP Setup Wizard
The Setup Wizard is designed to help you configure the basic settings required to
get the AP up and running.
Step 1 Select How the AP will be Managed — To manage the AP using the Edgecore
ecCLOUD controller, select “Yes, I will manage this device by ecCloud controller,”
and then continue to Step 6.
To manage the AP using the an Edgecore EWS-series controller, select “Yes, I will
manage this device by EWS-Series controller,” and then continue to Step 2.
Otherwise, select “No, I will be operating this device in stand-alone mode” and
continue to Step 3.
Figure 2: Select ecCloud, EWS Controller, or Stand-Alone
If you select to manage the AP using the Edgecore ecCLOUD controller, go to
cloud.ignitenet.com to register your AP. Log in and select Devices from the menu.
Click Add Device and enter the AP serial number and MAC address to register the
AP with your cloud network. The serial number and MAC address can be found on
the product packaging or label.
Note: This manual describes the configuration interface for stand-alone mode.
Refer to the Edgecore ecCLOUD Controller User Manual for information on
configuring the AP through the cloud interface or the EWS-Series Controller User
Manual for information on managing the AP through an EWS controller.