Chapter 4
| Wireless Settings
Radio Settings
– 68 –
Broadcast Rate — Allows a limit to be placed on the wireless bandwidth
consumed by broadcast packets.
Radio 2.4 Ghz — Options: 5.5M, 6M, 9M, 11M, 12M, 18M, 24M, 36M,
48M, 54M; Default: 5.5M
Radio 5 Ghz — Options: 6M, 9M, 12M, 18M, 24M, 36M, 48M, 54M;
Default: 6M
RF Isolation — When enabled, clients are isolated between different radio
cards.
SSID Isolation — When enabled, clients are isolated between different SSIDs
on the same radio cards.
Wireless Networks —
General Settings
Figure 43: Radio Settings (General Settings)
The following items are displayed in this section of the Wireless Settings page:
Status — Enables or disables the wireless service on this VAP.
SSID — The name of the basic service set provided by a Virtual Access Point
(VAP) interface. Clients that want to connect to the network through the access
point must set their SSID to the same as that of the access point’s VAP interface.
(Default: Edgecore5G-# (where # is 1-16) for 5 GHz, Edgecore2.4G-#
(where # is 1-16) for 2.4 GHz; Range: 1-32 characters)
Site Survey — Scans for all wireless networks that are broadcasting their SSID.
Broadcast — The SSID can be broadcast at regular intervals so that wireless
stations searching for a network connection can discover it. This allows wireless
To Next Page
Loading...
