Edge-Core EAP102 - Telnet; Edgecore Networks Discovery Tool; Figure 60: Telnet Server Settings; Figure 61: Discovery Agent Settings

Chapter 5 | System Settings
Services
– 90 –
Telnet Telnet is a remote management tool that can be used to configure the access point
from anywhere in the network. However, note that Telnet is not secure from hostile
attacks.
Figure 60: Telnet Server Settings
The following items are displayed on this page:
 Telnet Server — Enables or disables Telnet access to the access point.
(Default: Enabled)
 Port — Sets the TCP port number for the Telnet server on the access point.
(Range: 1-65535; Default: 23)
 Allow Telnet from WAN — Allows Telnet management access from the WAN.
Edgecore Networks
Discovery Tool
The Discovery Tool agent enables the AP to find other Edgecore devices in the
same Layer 2 network. See “Device Discovery” on page 98 to scan the network for
devices.
Figure 61: Discovery Agent Settings
The following items are displayed on this page section:
 Discovery Agent — Enables the discovery agent. (Default: Enabled)
 Allow over WAN — Enables the discovery agent to operate over the port
connected to the Internet source. (Default: Enabled)