Chapter 5
| System Settings
Upload Certificate
– 87 –
Upgrading Firmware You can upgrade new access point software from a local file on the management
workstation. New software may be provided periodically from Edgecore.
After upgrading new software, you must reboot the access point to implement the
new code. Until a reboot occurs, the access point will continue to run the software
it was using before the upgrade started. The access point supports dual software
images, so if newly loaded software is corrupted, the alternate image will be used
on the next reboot. Configuration settings are stored separately from the software,
so the current settings will always be used for any new software. However, note that
if the current configuration settings are corrupted, the system defaults will be used.
Note:
If the uploaded firmware is older than the current version, the device forces
the “Keep current settings after upgrade” option to unchecked.
Figure 56: Upgrading Firmware
Upload Certificate
The Upload Certificate page allows you to upload a unique security certificate from
a trusted certification authority for secure access (an encrypted connection) to a
configured HTTPS captive portal. Alternatively, you can also reset to use the default
certificate.
To Next Page
Loading...
