Chapter 4
| Wireless Settings
Radio Settings
– 75 –
Network Behavior — One of the following connection methods must be
specified. (Default: Route to Internet)
Bridge to Internet — Configures an interface as attached to the WAN.
Traffic from this interface is directly bridged into the Internet. (See
Figure 29, “Bridge to Internet", on page 47.)
Route to Internet — Configures an interface as a member of the LAN.
Traffic from this interface is routed across the access point and out through
an interface which is bridged to the Internet. (See Figure 30, “Route to
Internet", on page 47.)
Network Name — The network to be routed. The default is “Default
local network” as displayed under LAN Settings – Local Network.
Add to Guest Network — This interface can only support the guest
network.
Hotspot Controlled — This interface can only support hotspot services.
Configure Hotspot — Opens Hotspot Settings page.
Walled Garden — Configures the Walled Garden list on the Hotspot
Settings page.
VLAN Tag Traffic — Tags any packets passing from this VAP (virtual access
point) to the associated Ethernet port with a VLAN ID configured under
“VLAN Settings” on page 78.
VLAN Id — Selects the configured VLAN ID with which to tag the VAP
traffic.
VLAN Settings — Opens the VLAN Settings page.
Dynamic VLAN — The RADIUS server provides the access point with the
user VLAN information. The access point assigns the associated user to the
related VLAN.
Default VLAN Behavior — Specifies the behavior (Accept or Reject)
when a client’s VLAN ID is not defined on the RADIUS server. The
default setting is Reject.
Reject — A client cannot connect to the SSID when the client’s
VLAN ID is not defined on the RADIUS server.
Accept — A client can connect to the SSID with an assigned or
untagged VLAN ID when the client’s VLAN ID is not defined on the
RADIUS server.
To Next Page
Loading...
