Chapter 27
| OAM Commands
– 864 –
efm oam link-monitor
frame threshold
This command sets the threshold for errored frame link events. Use the no form to
restore the default setting.
Syntax
efm oam link-monitor frame threshold count
no efm oam link-monitor frame threshold
count - The threshold for errored frame link events. (Range: 1-65535)
Default Setting
1
Command Mode
Interface Configuration
Command Usage
If this feature is enabled, an event notification message is sent if the threshold is
reached or exceeded within the period specified by the efm oam link-monitor
frame window command. The Errored Frame Event TLV includes the number of
errored frames detected during the specified period.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam link-monitor frame threshold 5
Console(config-if)#
efm oam link-monitor
frame window
This command sets the monitor period for errored frame link events. Use the no
form to restore the default setting.
Syntax
efm oam link-monitor frame window size
no efm oam link-monitor frame window
size - The period of time in which to check the reporting threshold for
errored frame link events. (Range: 10-65535 units of 10 milliseconds)
Default Setting
10 (units of 100 milliseconds) = 1 second
Command Mode
Interface Configuration
Command Usage
If this feature is enabled, an event notification message is sent if the threshold
specified by the efm oam link-monitor frame threshold command is reached or
To Next Page
Loading...
Need help?
General